Panels built to your drawing and specification
LT power and motor control panels, power-factor and changeover panels, VFD and PLC control panels, and HT / MV panels with bus duct, built to IEC 61439 and tested before dispatch.
- LT panels: PCC, MCC, DB
- APFC, AMF and VFD panels
- Control and PLC panels
- Routine tests and FAT
Capabilities that cover the whole job
LT, APFC / AMF / VFD, control and HT / MV panels, built to your specification.
LT panels
PCC, MCC and distribution boards for power and motor control.
APFC, AMF & VFD panels
Power-factor correction, auto mains failure and variable-speed drive panels.
Control & PLC panels
Control, automation and PLC panels built to your schematic.
HT / MV panels & bus duct
Medium- and high-voltage panels and bus duct systems, engineered to order.
What every panel is built and checked to
IEC 61439
Low-voltage switchgear and controlgear assemblies built to IEC 61439.
IP ratings
Enclosure protection selected for the installation: indoor, outdoor, dusty or wet.
Routine tests
Routine tests on every panel before it leaves, with the record supplied.
Factory acceptance test
FAT at our works where you want to witness the tests.
A clear path from brief to handover
Send your requirement
Share your single-line diagram and ratings, or configure the panel with our spec builder.
Review
Our engineers check the ratings, clarify open points and confirm the specification.
Quote
An itemised offer with drawings for approval.
Build
The panel is built to the approved drawings.
Test & dispatch
Routine tests and FAT before dispatch, then delivery and commissioning support.
Documented, accountable, ready to use
Every engagement ends with clear documents and a named point of contact, so your team always knows what was delivered and who to call.
Request a quote- GA and schematic drawings for approval
- Itemised bill of materials
- Routine test record
- Factory acceptance test where agreed
- As-built drawings
- Installation and commissioning support
Equipment we supply for this
Questions we’re often asked
What do you need to quote a panel?
Your single-line diagram and ratings, or a description of the duty. If you have no drawing, tell us the loads and our engineers will help define the panel.
Do you build to a customer drawing?
Yes. Panels are built to your drawing and specification.
Can I witness the tests?
Yes, a factory acceptance test can be arranged where you want to witness it. Tell us at enquiry.
Which panels do you build?
LT panels (PCC, MCC, distribution boards), APFC, AMF and VFD panels, control and PLC panels, and HT / MV panels with bus duct.
Can you also install and commission?
Yes. Installation and commissioning support can be part of the quotation.
Tell us what you need — we’ll size it right.
Share your requirement and our engineers will respond within 24 hours with a clear, itemised offer.