Cable Lugs & Glands
Crimp lugs and cable glands for terminating power and control cables.
On request- StandardIS 8309 (lugs), IEC 62444 (glands)

Download specification sheet (PDF)
Power cables for carrying electricity from supply to loads, in LT and HT grades with copper or aluminium conductors.
Every field is optional - tell us what you know and we will confirm the rest in the quotation.
Representative image. The actual product, make and appearance depend on the supplier and your specification.
Also searched as: XLPE cable, XLPE power cable, LT power cable, HT power cable, 1.1 kV XLPE cable, copper and aluminium power cable
Choose cable size by three checks, and use the largest result: current-carrying capacity after installation derating, voltage drop over the route length, and short-circuit withstand for the protective device's clearing time. Selecting by current alone often leaves a long cable with excessive voltage drop or a cable that cannot withstand the fault.
Mistakes include ignoring grouping and soil thermal resistivity, forgetting bending radius, and poor lug selection. Use the motor current and cable calculator as a first check, and see cable lugs and glands for terminations.
Ratings, dimensions and certification are confirmed against your enquiry. Use Send an enquiry and our engineers will respond within 24 hours.
XLPE insulation allows a higher operating temperature, so a given size carries more current and withstands short-circuit heating better. PVC is cheaper and common for lower-voltage, lighter duty. HT cables are generally XLPE. Decide on load, voltage and budget.
Current rating is only one criterion. A long run may produce excessive voltage drop, and the cable must also survive the short-circuit current for the time the protection takes to clear it. Check all three, plus installation derating.
XLPE means cross-linked polyethylene, a cable insulation. Compared with PVC it can run at a higher conductor temperature, so a cable of the same size can usually carry more current. It also has good electrical and ageing properties for power distribution.
PVC insulated LT power cables are covered by IS 1554 and XLPE insulated cables by IS 7098. Always state the standard, voltage grade and conductor material in your enquiry so the cable offered matches your specification.
Copper conducts better, so a smaller conductor size carries the same current. Aluminium is lighter and is commonly used for larger sizes, but needs a bigger cross-section and suitable lugs and terminations. Your load and site conditions decide.
Send the voltage grade, conductor material, number of cores and size in sq mm, PVC or XLPE insulation, armoured or unarmoured, applicable standard and length. SKE Bharat is based in Rajaji Nagar, Bangalore, and sends a quotation within 24 hours.
| Cable Type | Power cable, LT and HT |
|---|---|
| Standard | IS 1554 (PVC, LT), IS 7098 (XLPE, HT) |
| Conductor | Copper or aluminium |
| Insulation | PVC or XLPE |
| Voltage Grade | 1.1 kV to 33 kV |
| Typical Use | Power distribution to panels, motors and plant |